(1) When the ultra-high pressure washer is working, the hose must not be twisted, and try to avoid bending. If bending is necessary, ensure that the bending radius is not too small, generally not less than 15 times the outer diameter of the pipe, otherwise the outer steel wire of the reinforcement layer will be stretched and the inner steel wire will be compressed, thereby reducing the entire ultra-high pressure hose. Compressive strength, which ultimately affects the service life of the hose. (2) When the ultra-high pressure washer is in working state, the ultra-high pressure hose cannot be crushed…
(1) When the ultra-high pressure washer is working, the hose must not be twisted, and try to avoid bending. If bending is necessary, ensure that the bending radius is not too small, generally not less than 15 times the outer diameter of the pipe, otherwise the outer steel wire of the reinforcement layer will be stretched and the inner steel wire will be compressed, thereby reducing the entire ultra-high pressure hose. Compressive strength, which ultimately affects the service life of the hose.
(2) When the ultra-high pressure washer is in working state, the ultra-high pressure hose cannot be crushed by heavy objects, and the sharp objects will not be crushed and not bent. The outer layer should be protected from excessive wear; the high-pressure hose used for suspension should be fixed firmly in a short distance. .
(3) During the operation of specific cleaning operations, it is necessary to avoid frequent opening and closing of the hand-held high-pressure spray gun, so as to reduce the influence of pressure pulses on the hose, thereby prolonging the service life of the hose.
(4) When installing and disassembling the connection of the ultra-high pressure hose, it is not possible to forcefully disassemble and force the screw. It is necessary to protect the thread of the connecting thread. At the same time, it is required to apply lubricating oil on the outer surface of the thread during installation, and use a protective sleeve to protect the connecting thread after disassembly. .
(5) When the ultra-high pressure hose is not used for a long time, the internal water should be drained, and the hose should be bent and coiled according to the specified size and then placed horizontally. Special attention should be paid to the bending near the joint of the ultra-high pressure hose. The joint should be coated with anti-rust oil to avoid contact with high temperature, high pressure and strong corrosive media.
(6) In order to prevent accidents and hurt people when the joint falls off or is damaged, the ultra-high pressure hose should be provided with a steel wire braided protective sleeve at the connection to connect both ends.
